Veeam Support Knowledge Base
VM Disks Support for oVirt Incremental Backup

VM Disks Support for oVirt Incremental Backup

KB ID:	4208
Product:	Veeam Backup for Red Hat Virtualization \| 1a \| 2.0 \| 3.0 \| 4.0 Veeam Backup for Oracle Linux Virtualization Manager and Red Hat Virtualization \| 4.1
Published:	2021-10-07
Last Modified:	2024-05-29

By subscribing, you are agreeing to have your personal information managed in accordance with the terms of Veeam's Privacy Notice.

Cheers for trusting us with the spot in your mailbox!

Now you’re less likely to miss what’s been brewing in our knowledge base with this weekly digest

Oops! Something went wrong.

Please, try again later.

Challenge

A backup job for an Oracle Linux Virtualization Manager and Red Hat Virtualization VM could not enable incremental backup support. One of the following warnings may occur:

Unable to enable ovirt incremental backups for disk '':. Full scan backups will be performed. Please see KBxxxxx for more information

Unable to create incremental backup: Cannot backup VM. Incremental backup is not supported.

Unable to backup disks incrementally, using full scan backup.

^{This error specifically occurs when the disk is raw.}

Solution

Here are the two most common causes of this issue and how to resolve them.

Cause 1: Incremental Backup Support is disabled at the system level

Incremental backup support may be disabled at the system level.

Solution:

Connect to the ovirt-engine system via ssh
Execute the following commands:

engine-config -s "IsIncrementalBackupSupported=true"
systemctl restart ovirt-engine

Cause 2: VM Disk created without Incremental Backup support

When creating a VM disk, if the option for 'Enable Incremental Backup' is not enabled, the disk will be created in RAW format and won't support incremental backups. After the disk has been created, the 'Enable Incremental Backup' option will be greyed out and cannot be enabled.

Solution:

There are two methods to resolve this limitation.

(Recommended) Create a snapshot of the VM. Then, edit the disk and enable the Incremental Backup option.

Note: The snapshot must remain in place. If it is removed, the Incremental Backup option will become disabled. In the long term, you should rebuild the VM/disk to have Incremental Backup enabled on the disk at the time of creation.
Convert the disk from RAW to QCOW2
Review: KB4345: Converting Disk from RAW to QCOW2 to Allow For Incremental Backup

To submit feedback regarding this article, please click this link: Send Article Feedback
To report a typo on this page, highlight the typo with your mouse and press CTRL + Enter.

Spelling error in text

Thank you!

Your feedback has been received and will be reviewed.

Oops! Something went wrong.

Please, try again later.

You have selected too large block!

Please try select less.

KB Feedback/Suggestion

This form is only for KB Feedback/Suggestions, if you need help with the software open a support case

Product

Topic

Description

By submitting, you are agreeing to have your personal information managed in accordance with the terms of Veeam's Privacy Notice.

This site is protected by hCaptcha and its Privacy Policy and Terms of Service apply except as noted in our Privacy Policy.

Verify your email to continue your product download

We've sent a verification code to:

An email with a verification code was just sent to

Didn't receive the code? Click to resend in sec

Didn't receive the code? Click to resend

Thank you!

Your feedback has been received and will be reviewed.

Oops! Something went wrong.

Please, try again later.